![]() ![]() But in simple cases, the debugger should figure it out on its own. If you need to, provide a path mapping. Reverse SSH Tunneling is the ability to connect to a remote host and make a link between the remote hosts port of choice to a local port on the attacking.Enable tunneling through the VS Code Desktop UI. Go to Project / Properties, and switch to Server tab You have two paths to work with tunnels: Run the tunnel command of the code command-line interface (CLI).This part is identical to a regular remote debugging configuration. Xdebug.start_with_request=trigger Configure PHP Projectīack on your machine, configure the PHP project. Zend_extension = PATH_TO_XDEBUG_EXTENSION But make sure to configure Xdebug on the server. SSH Tunnel takes care of forwarding the Xdebug connections from the remote server to your machine. You should see similar output as on the image above. By default it will listen in all interfaces (0.0.0.0) and choose a random port. When you are logged in, you can optionally check if the SSH tunnel is in place. The -R option instructs the SSH client to forward port 9003 from a remote machine to localhost:9003 where PHP Tools Debugger will be listening. If you are, however, running older Windows you'll need to install Putty.Īssuming you are on Windows 10, open a command prompt and run this command: ssh -R 9003:localhost:9003 command opens an SSH session to the ubuntu server and logins with devsense account (replace with your login and server). If you are running Windows 10 you should have ssh command. The server has to have an SSH server running and you must be able to login into it with an SSH client. First, open an ssh connection to your server (userhost) specifying. Another solution is to use an SSH tunnel (or port forwarding).įor this solution to work, there is an obvious requirement. The best option I found was to open a dedicated Chrome session through an SSH tunnel. The client uses the provided remote host information to initiate the connection and if the credentials are verified, establishes the encrypted connection. One option would be to install a DBGp server on the network with the development server, but your administrator might rather watch cat videos than do this. An SSH client is an application you install on the computer which you will use to connect to another computer or a server. That makes PHP remote debugging impossible. Xdebug from the remote server can't directly connect to your machine through all the firewalls, NAT routers or other network infrastructure. ![]() When you are on a different network than the server with a PHP application that you need to debug, you might have a problem. ![]()
0 Comments
Leave a Reply. |